First remove any mill glaze a hard shiny surface on one side of the siding by sanding.
Painting cedar shake sidings seven lakes nc.
How to prepare old cedar shakes for repainting.
Stains dry rapidly and fresh stain applied over dried stain will show lap marks.
Be careful when painting very old cedar siding.
See the difference our team made in painting cedar shake siding to restore this house in phillipsburg nj.
If possible stain all sides of the siding before installation.
Loosened photodegraded surface fibers and any loosened remaining finish must be removed prior to re finishing.
The gap between the shakes acts like a miniature funnel in a driving rainstorm.
Scrape any peeling paint chips off the shakes with a scraper.
Hang the shakes from a clothesline while they dry.
The original cedar shake siding was faded and disc.
See how the pros sand prep prime and paint a cedar shingle home.
Even then the paint is not expected to last long.
In refinishing painted or solid color stained siding and trim removal of the old coating may be required.
Painting bare cedar shakes that are already installed is very hard and can lead to other pesky problems down the road.
Remove as much of the old paint as possible as the more prep work you do.
Surface preparation is the key to success when dealing with weathered wood.
This is necessary if for example the old finish is severely cracked or is peeling.
While extremely old cedar can be painted it requires heavy preparation.
Exterior western red cedar surfaces only need to be refinished when the old coating has worn thin and no longer affords the wood protection.
A step by step guide to walk you through the pro.
One of the issues of painting cedar shakes after they are installed is that you don t get paint on critical parts of the shakes that can get wet.
All done by hand to ensure full coverage.
Properly primed a 100 percent acrylic latex paint will provide decades of protection for cedar siding shingles.
Pour the paint into a five gallon bucket.
Next dip each shake into the paint leaving only an inch or two not painted at the top where it is being held.
Powerwash the siding to remove any excess dirt or paint with a low pressure pressure washer.
Remove the shake and hold it over the bucket while wiping off the excess with a paint brush.