Osha Roof Safety Rail Requirements

1910 29 b 3 osha requires that guardrail systems must be able to withstand a force of at least 200 lbs of point load without failure.

Osha roof safety rail requirements.

Osha requires that workers exposed to a fall hazard must have fall protection. The safety monitor is always a competent person 29 cfr 1926 500 b. Manila or synthetic rope used for top rails or midrails are inspected as necessary to ensure that the rope continues to meet the strength requirements in paragraphs b 3 and 5 of this section. Osha 1910 29 b contains system requirements that employers must follow to ensure guardrail systems will protect workers from falling to lower levels.

1910 29 b 1 the top edge height of top rails or equivalent guardrail system members are 42 inches 107 cm plus or minus 3 inches 8 cm above the walking working surface. Each roof railing system is designed by a sales engineer to ensure the highest level of safety. All mesh crossings shall be secured to prevent enlargement of the mesh opening. Or on roofs 50 feet 15 25 m or less in width the use of a safety monitoring system alone is permitted 29 cfr 1926 501 b 10.

The warning line system shall consist of ropes wires or chains and supporting stanchions 29 cfr 1926 502 f 2. Note to paragraph b of this section. Keeguard roof railing exceeds this requirement and has the testing documents to prove it. 1926 502 c 7 the maximum size of each safety net mesh opening shall not exceed 36 square inches 230 cm nor be longer than 6 inches 15 cm on any side and the opening measured center to center of mesh ropes or webbing shall not be longer than 6 inches 15 cm.