Osha Flat Roof Fall Protection Requirements

Implement safe work practices to reduce the possibility of falls.

Osha flat roof fall protection requirements.

Osha defines what fall protection is required based on how close employees are to the edge of the roof. Fall protection systems and other equipment they will be using on the job. Lay headers sheets of roofing or other materials no closer than 5 feet inside the edges of the roof and parallel to the roofline. If there is a fall risk it needs to be addressed.

How it is addressed depends on the type of work being done. When the fall protection measures listed above are not used mark the edges of the flat roof with headers and warning lines to notify workers of potential fall hazard areas using the following guidelines. Understand the requirements of osha s fall protection standards at 29 cfr 1926 subpart m to protect workers exposed to falls six feet or more above a lower level. With regard to fall protection requirements applicable to the construction work itself 1926 501 b 10 low slope roofs requires conventional fall protection a combination of a monitoring system and warning line or on roofs of 50 feet or less in width a monitoring system alone i e without a warning line be used.

Less than 6 feet from the roof edge. Supervise workers to ensure fall. Between 6 feet and 15 feet from the roof edge. Employers are to ensure that each employee is protected from falling by using fall.